关闭防火墙及关闭防火墙开机自启
[root@localhost ~]# systemctl stop firewalld.service
[root@localhost ~]# systemctl disable firewalld.service
Removed symlink /etc/systemd/system/dbus-org.fedoraproject.FirewallD1.service.
Removed symlink /etc/systemd/system/basic.target.wants/firewalld.service.
查看SeLinux状态
[root@localhost ~]# sestatus SELinux status: enabled SELinuxfs mount: /sys/fs/selinux SELinux root directory: /etc/selinux Loaded policy name: targeted Current mode: enforcing Mode from config file: error (Success) Policy MLS status: enabled Policy deny_unknown status: allowed Max kernel policy version: 28
临时关闭SeLinux
[root@localhost ~]# setenforce 0
查看SeLinux状态
[root@localhost ~]# sestatus
SELinux status: enabled
SELinuxfs mount: /sys/fs/selinux
SELinux root directory: /etc/selinux
Loaded policy name: targeted
Current mode: permissive
Mode from config file: error (Success)
Policy MLS status: enabled
Policy deny_unknown status: allowed
Max kernel policy version: 28
永久关闭SeLinux,需要重启机器
修改配置文件/etc/selinux/config,将SELINU置为disabled
查看修改后:
[root@localhost ~]# cat /etc/selinux/config
# This file controls the state of SELinux on the system.
# SELINUX= can take one of these three values:
# enforcing - SELinux security policy is enforced.
# permissive - SELinux prints warnings instead of enforcing.
# disabled - No SELinux policy is loaded.
# SELINUX=enforcing
SELINUX=disabled
# SELINUXTYPE= can take one of three two values:
# targeted - Targeted processes are protected,
# minimum - Modification of targeted policy. Only selected processes are protected.
# mls - Multi Level Security protection.
SELINUXTYPE=targeted
重启后,查看SeLinux状态
[root@localhost ~]# sestatus
SELinux status: disabled