# 基础配置
# ==================================================================node1
vi /etc/hostname node1 vi /etc/sysconfig/network-scripts/ifcfg-ens33 # BOOTPROTO=dhcp BOOTPROTO=static # ONBOOT=no ONBOOT=yes IPADDR=192.168.6.131 NETMASK=255.255.255.0 GATEWAY=192.168.6.2 DNS1=192.168.6.2 # 重启下网络服务 systemctl restart network.service # service network restart # 查看网络状态 systemctl status network.service # 查看IP ip addr # 直接关闭防火墙 # 停止firewall systemctl stop firewalld.service # 禁止 firewall 开机启动 systemctl disable firewalld.service reboot
# ==================================================================node1
# 配置hosts vi /etc/hosts
192.168.6.131 node1 192.168.6.132 node2 192.168.6.133 node3 # 关闭SELinux vi /etc/sysconfig/selinux SELINUX=disabled vi /etc/ssh/sshd_config #RSAAuthentication yes #启用 RSA 认证 #PubkeyAuthentication yes #启用公钥私钥配对认证方式 #AuthorizedKeysFile .ssh/authorized_keys #公钥文件路径(和上面生成的文件同) systemctl restart sshd.service # service sshd restart # network vi /etc/sysconfig/network NETWORKING=yes HOSTNAME=node1 # 需将Windows文件上传到虚拟机中需配置 # C:WindowsSystem32driversetc 在host文件中加入对应ip与机器名 192.168.6.131 node1 192.168.6.132 node2 192.168.6.133 node3 shutdown -h now # 快照 初始化 # 克隆 node2 node3
# ==================================================================node2
vi /etc/hostname node2 vi /etc/sysconfig/network NETWORKING=yes HOSTNAME=node2 vi /etc/sysconfig/network-scripts/ifcfg-ens33 # BOOTPROTO=dhcp BOOTPROTO=static # ONBOOT=no ONBOOT=yes IPADDR=192.168.6.132 NETMASK=255.255.255.0 GATEWAY=192.168.6.2 DNS1=192.168.6.2 systemctl restart network.service shutdown -h now # 快照 初始化
# ==================================================================node3
vi /etc/hostname node3 vi /etc/sysconfig/network NETWORKING=yes HOSTNAME=node3 vi /etc/sysconfig/network-scripts/ifcfg-ens33 # BOOTPROTO=dhcp BOOTPROTO=static # ONBOOT=no ONBOOT=yes IPADDR=192.168.6.133 NETMASK=255.255.255.0 GATEWAY=192.168.6.2 DNS1=192.168.6.2 systemctl restart network.service shutdown -h now # 快照 初始化
转载于:https://www.cnblogs.com/zcf5522/p/9753480.html