$ git config --global user.name "Your Name" $ git config --global user.email your@example.com $ git config --list user.name=yueruitao user.email=1316751406@qq.com core.repositoryformatversion=0 core.filemode=false core.bare=false core.logallrefupdates=true core.ignorecase=true ****** git config log.date iso-local 2018-11-03 03:30:04 +0000 git config log.date iso-strict-local 2018-11-03T03:30:04+00:00 *** --date=<format> Only takes effect for dates shown in human-readable format, such as when using --pretty. log.date config variable sets a default value for the log command’s --date option. By default, dates are shown in the original time zone (either committer’s or author’s). If -local is appended to the format (e.g., iso-local), the user’s local time zone is used instead. --date=relative shows dates relative to the current time, e.g. “2 hours ago”. The -local option has no effect for --date=relative. --date=local is an alias for --date=default-local. --date=iso (or --date=iso8601) shows timestamps in a ISO 8601-like format. The differences to the strict ISO 8601 format are: a space instead of the T date/time delimiter a space between time and time zone no colon between hours and minutes of the time zone --date=iso-strict (or --date=iso8601-strict) shows timestamps in strict ISO 8601 format. + --date=rfc (or --date=rfc2822) shows timestamps in RFC 2822 format, often found in email messages. + --date=short shows only the date, but not the time, in YYYY-MM-DD format. + --date=raw shows the date as seconds since the epoch (1970-01-01 00:00:00 UTC), followed by a space, and then the timezone as an offset from UTC (a + or - with four digits; the first two are hours, and the second two are minutes). I.e., as if the timestamp were formatted with strftime("%s %z")). Note that the -local option does not affect the seconds-since-epoch value (which is always measured in UTC), but does switch the accompanying timezone value. + --date=unix shows the date as a Unix epoch timestamp (seconds since 1970). As with --raw, this is always in UTC and therefore -local has no effect. + --date=format:... feeds the format ... to your system strftime, except for %z and %Z, which are handled internally. Use --date=format:%c to show the date in your system locale’s preferred format. See the strftime manual for a complete list of format placeholders. When using -local, the correct syntax is --date=format-local:.... + --date=default is the default format, and is similar to --date=rfc2822, with a few exceptions: there is no comma after the day-of-week the time zone is omitted when the local time zone is used