• UHP Command List


    UHP Command List

    (NMS)UHP# help
    *** - command allows remote execution
              ----------  IP set-up
    ip address IP_ADDR IP_MASK [1-4095]   - Add IP address to interface [VLAN] ***
    ip route IP_ADDR IP_MASK IP_ADDR [1-4095]   - Add static route [VLAN] ***
    ip map IP_ADDR IP_MASK ml|mm|mh|mp 1-64000 1-2040 [0-500] [0-2040] [0-4095]   - Route network to modulator SVLAN STATION [Policy] [TrSh] [VLAN] ***
    bridge map ml|mm|mh|mp 1-64000 1-2040 [0-500] [0-2040] [0-4095]   - Bridge map SVLAN STATION [Policy] [TrSh] [VLAN] ***
    svlan receive 1-64000 [0-4095]   - Add SVLAN receive [VLAN] ***
    ip delete IP_ADDR IP_MASK [0-4095]   - Delete IP address, route or map [VLAN] ***
    bridge delete 0-4095   - Delete bridge [VLAN] ***
    svlan delete 1-64000 [0-4095]   - Delete IP address, route or map [VLAN] ***
    ip update off|on   - Routing table update prevention ***
    mcast off|static|igmp 1-30   - Multicast settings MODE TIMEOUT(min) ***
    interface ethernet 0-1000 full|half 1-2   - Ethernet interface settings SPEED (0|10|100|1000(UHP-2XX only) M) DUPLEX PORT; SPEED 0 means AUTO ***
              ----------  System statistics
    show profiles   - Show profile settings
    show interface ethernet|2demod|demod|modulator|network|wbm   - Interface stats
    show system   - Show system parameters
    show errors   - Show device errors
    show memory ram|flash|config   - Show memory state
    show service cotm|tuning   - Services stats
    clear counters all|ethernet|2demod|demod|modulator|tdma|ip|redtl|profile|acc|crypto|dhcp|snmp|dns|nms|gtp|cotm|wbm   - Reset stats ***
              ----------  Protocol statistics
    show ip [0-4096]   - Routing table [VLAN] 4096-untagged
    show arp   - ARP table
    show rtp   - RTP header compression statistics
    show snmp   - Display SNMP parameters
    show dhcp   - Display DHCP parameters
    show multicast   - Display multicast parameters
    show acceleration all|stat|sessions|buf|rem STRING   - TCP acceleration stats
    show shaper   - Print Traffic Shaper statistics
    show nat   - Print NAT statistics
    show red   - Display stations redundancy table
    show mac STRING   - MAC table [pX|mac]
    clear mac STRING   - Clear MAC table [pX|mac] ***
              ----------  Satellite network statistics
    show net   - Display network state 
    show stations traffic priority [1-16000]   - Display stations traffic by priority
    show stations traffic [1-16000]   - Display stations traffic statistics
    show stations rf [1-16000]   - Display stations RF statistics
    show stations [1-16000]   - Show station statistics
    show mf   - Show MF inroutes statistics
    show modcods   - Show modcods ACM statistics
    show tlc   - Show SCPC TLC statistics
    show backup   - Show redundancy backup statistics
    show nms   - Show NMS statistics
              ----------  Demodulator utilities
    demod phase-graph [0-8]   - Display phase constellation
    demod bert qpsk|re|data   - Bit error rate meter
    demod antenna [1-2] [0-800] [0-800]   - Antenna pointing mode [RF min] [RF max]
              ----------  Auxiliary RF control
    modulator tx off|on   - Tx carrier control ***
    modulator level 10-460   - TX power level (x -0.1 dBm) ***
    modulator global cn [0-30]   - Set global level from far end C/N (0-disable) ***
    modulator inversion off|on   - Spectrum inversion ***
    modulator reference off|on   - Modulator 10 MHz output ***
    modulator power off|on   - Modulator 24V BUC power ***
    modulator tlc level 10-460   - Max TLC TX level (x -0.1 dBm) ***
    modulator tlc off|on   - Automatic transmit level control ***
    demod lnb power off|on   - LNB power control ***
    demod reference off|on   - TDMA RX connector 10 MHz output ***
    demod inversion 1-2 off|on   - Demodulator inversion [1|2] [off|on] ***
    rf lo 0-33000000 0-33000000 0-35000000   - RF LO frequencies RX1, RX2, TX ***
              ----------  Profile and stations table control
    profile 0-8 copy 1-8   - Copy profile N1 (0-active) to profile N2 ***
    profile 0-8 timeout 10-250   - Timeout ***
    profile 1-8 type auto|manual none|scpc|starrem|damarem|hmesh|crosspol|slave|master|asic   - Mode ***
    profile 1-8 autorun on|off   - Autorun ***
    profile 1-8 crosspol 950000-32000000 0-65535   - CrossPol FREQ DURATION ***
    profile 1-8 rx d2 950000-32000000 300-200000   - Rx2 FREQ SYMRATE(200000(200X)/64995(200)) ***
    profile 1-8 rx 950000-32000000 300-200000   - Rx FREQ SYMRATE(200000(200X)/64995(200)) ***
    profile 1-8 tx 950000-32000000 300-64995 1-127   - Tx FREQ SYMRATE(64000(200X)/64995(200)) MODCOD(1-127(200X)/2-28(200)) ***
    profile 1-8 modulator on|off 10-460   - Modulator TX [on|off] TXLEVEL ***
    profile 1-8 tlc on|off scpctlc on|off 1-36 [1-239] STRING   - TLC [on|off] SCPC:TLC [on|off] MAXTXLVL [SCPC:DesiredC/N] [SCPC:peer IP] ***
    profile 1-8 hubless tdma 16-252 2-15 1-2040   - TDMA FRLEN SLLEN STNUM ***
    profile 1-8 hubless rf 950000-32000000 950000-32000000 100-8000 1-12   - Hubless RXFR TXFR SYMRATE MODCOD ***
    profile 1-8 dama 1-2 1-2040 1-99999999 1-99999999 950000-32000000 250-32000 1-127 off|on 20|05 1-360 off|on|purecarrier   - CH STN SN RSN FR SR MODCOD(1-127(200X)/2-28(200)) PILOTS ROFF TXLVL TXMODE ***
    profile 1-8 acm on|off 1-127 0-59   - ACM [on|off] MAXMODCOD(1-127(200X)/2-28(200)) THRESHOLD ***
    profile 1-8 demodulator polarization 13|18   - LNB voltage 13|18 V ***
    profile 1-8 demodulator 1-2 off|on 1-2   - DemX ON|OFF RX1|RX2 ***
    profile 1-8 satellite 0-179 0-59 East|West   - Satellite position (DEG MIN) ***
    profile 0-8 run   - Run profile N (0-run next) ***
    profile 1-8 dtts source location|value   - Profile DTTS source ***
    profile 1-8 dtts -20000-20000   - Manual profile DTTS value (us) ***
    station table 0-2040 on|off 0-100000 0-680 0-3 on|off   - Add/edit station (stnum>0 on serialnum shaper rq_profile TCPA); station table 0 on 1-2040 ...   - set size of table (stnum) ***
              ----------  Location and timing control
    timing source location|value|measure   - Timing source ***
    station dtts source location|value   - Station DTTS source ***
    station location 0-89 0-59 north|south 0-179 0-59 east|west   - Location LAT LON (DEG MIN) ***
    station dtts -20000-20000   - Manual station DTTS value (us) ***
              ----------  Overall control
    admin   - Switch to Administrator mode
    exit   - Log out from console ***
    clear interface ethernet|demod|mod|wbm|tdma   - Reinitialize interface ***
    clear arp-table   - Purge contents of ARP table ***
    clear dhcp   - Purge contents of DHCP table ***
    clear tuning   - Clear station tuning corrections ***
    time set 0-24 0-60 1-31 1-12 0-99   - Set date/time  HH MM DD MM YY ***
    time zone -12-12   - Set time zone ***
    unit key 0-15 [0-65535] [0-65535] [0-65535]   - Set features key
    watchdog reset|interrupt   - Watchdog timer overflow action ***
    reboot stop   - Stop delayed reboot ***
    reboot auto 3-250   - Auto reboot device [delay in minutes] ***
    reboot [0-1000]   - Reboot device [delay in minutes] ***
    network command 0-2000000000 STRING   - Command to terminal(s) by SN(11111111 - broadcast)
    network software send 1-3 [32-500]   - Send SW from RAM to stations FL_BANK [BW K]
    msg STRING   - Output text message ***
    set page off|on   - Set output paging ON|OFF ***
    custom [1-96] -2000000000-2000000000   - Customization ***
              ----------  Logging & debug
    show log   - Display logs
    clear log   - Purge logs
    logging stations off|on   - Logging events "Station UP/DOWN"
    debug show [0-10000000]   - Print debug [start record] ***
    debug mode off|on|restart|wrap|nowrap|profile-stop|on-persist|off-persist   - Debug control ***
    debug output off|console|network [1-65535]   - Debug output control ***
    debug system profile|lan|demodulator|modulator|tasks|buffers|config|interrupts|crypto 0x0-0xFFFF [1-10000000]   -  ***
    debug protocol snmp|dhcp|arp|nat|rip|ntp|rtp|tftp|igmp|http|icmp|telnet|ppp|nms|roaming|service 0x0-0xFFFF   -  ***
    debug service redundancy|tlc|acm|cotm|monitoring|script|policy|shaper|dns|spectrum|csim|asi|calibration|dualband|log|debug|tuning|egw 0x0-0xFFFF [1-10000000]   -  ***
    debug tdma frameplan|bandwidth|adjustment|reception|config|protocols|tts|bursts|mf 0x0-0xFFFF 0-65535 0-65535 [0-65535]   -  ***
    debug tcpa 0x0-0xFFFF   -  ***
    debug off   - Debug - off all ***
              ----------  Diagnostics
    ping IP_ADDR [1-1000000] [40-2000] [1-10000] [0-4095]   - IP Num Len Int/ms VLAN
    traffic analyzer off|on   - Traffic analyzer for trgen.
    traffic-generator off   - Disable traffic generator
    traffic-generator IP_ADDR 1-50000 36-2000 [0-4095] [1-50000] [36-2000]   - IP Pps Len [VLAN] [PpsMax] [PpsMin]
              ----------  Configuration and SW image management
    tftp-server IP_ADDR 0-4095   - TFTP server access
    config load default all|global|ip|profile|qos|stations|nat   - Load default config ***
    config load tftp STRING   - Load config from TFTP
    config save tftp STRING   - Save current config to TFTP
    config load 0-1   - Load config from specified profile ***
    config save 0-1   - Save current config to specified profile ***
    image load tftp STRING   - Load image by TFTP to RAM
    image load xmodem   - Load image with X-modem to RAM buffer
    image load flash   - Copy image from flash to RAM
    image write   - Write image from RAM to Flash
    erase flash   - Erase flash bank
              ----------  Boot control
    show boot   - Show software boot options
    boot main 0-2 0-1   - Main boot profile FLASH_BANK(0-auto) CONF_BANK ***
    boot temp 0-2 0-1   - Temp boot profile FLASH_BANK(0-none) CONF_BANK ***
    boot fallback timeout 1-10000   - Temp image auto fallback period (min) ***
    boot fallback reason uptime|link-up   - Auto fallback reason ***
    boot fallback stop   - Abandon auto fallback ***
              ----------  Crypto settings and utilities
    crypto key [1-256] STRING   - Set key INDEX KEY_HEX_STRING
    crypto service off|on 1-255   - Set service traffic encryption ON|OFF KEY_IND
    show crypto   - Show crypto statistics
              ----------  Help
    help   - Print this help
    NMS)UHP# 

    ============= End

  • 相关阅读:
    设置材质球的材质,是第几个
    转载渲染。
    系统的时间调不错,就是界面躁动太多,要是允许话还是在自己的界面中加入比较薄, 不过这个很方便。
    清除poly修改器的脚本,效果还好。
    不用string了用getFilenameFile 函数 索引名字更快
    判断平pickbutton 节点是否被删除, 这个事件放在点击事件之内。
    字符串加入到数组的号办法。
    收集每个mesh 面的id 号, 这个很有用,可以用来查找物体共有几个id 效果好。
    Evervolv android 源码编译
    zoj 2112 Dynamic Rankings(SBT in SegTree)
  • 原文地址:https://www.cnblogs.com/lsgxeva/p/13815435.html
Copyright © 2020-2023  润新知