[转]Installing and Configuring target iSCSI server on Windows Server 2012

最近研究Windows Server 2012，准备搭建一个高可用集群平台，想用windows iscsi target来模拟一个iSCSI SAN环境，原来现在的iSCSI Target不能安装了，看了一下windows server 2012里面已经预先集成了，安装就好，具体位置在 File Storage Role -> iSCSI Target Service，然后配置就可以了。

=====================================================

源地址：http://blogs.technet.com/b/meamcs/archive/2012/03/30/installing-and-configuring-target-iscsi-server-on-windows-server-8-beta.aspx

Installing and Configuring target iSCSI server on Windows Server 2012

iSCSI Software Target is now part of windows Server 8 Beta Roles and features, In this post i will walkthrough installing and configuring iSCSI software target.

Important Notes:

- iSCSI Target server now is integrated with Windows Failover clustering to provide HA for iSCSI target server, however in this post we will be  configuring a stand-alone iSCSI target server.

- Windows PowerShell can be used to install and configure iSCSI target server.

Environment details:

- Single iSCSI server IP address: 192.168.0.217

- File server “ServerA” IP address: 192.168.0.215

- File server “ServerB” IP address: 192.168.0.216

1. To install Windows server 8 iSCSI target open Server Manager and click Add Roles and Features then walkthrough the installation as per the below screenshots

2. After installation is complete successfully we will now configure the iSCSI target server as per the following

- We will have single VHD of 5 VHDs

- Access is allowed to two file server nodes

            o 192.168.0.215

            o 192.168.0.216

- Storage target name is File Server

To complete iSCSI target server the configuration go to Server Manager , click File and Storage Services then follow the screenshots below;

Go to iSCSI Virtual disks and click “Launch the New Virtual Disk wizard to create a virtual disk” and walk through the Virtual Disks and targets creation

3. To connect File Server nodes to iSCSI target open Server Manager click Tools and select iSCSI Initiator then proceed with the configuration as per the below screenshots

Now we open disk management to make sure that the disk is presented correctly

Repeat step 3 for the second file server node.

 

 

Windows Server 8, iSCSI target, Windows Server 2012