转：How to Disable the SELinux on RHEL 6

In Redhat Enterprise Linux 6 (RHEL 6) minimal server installation, SELinux is set to enable. To disable SELinux, without having to reboot, you can use the setenforce command as below:

[root@rhel6 ~]# setenforce 0 

To disabled the SELinux on your next reboot, please change “SELINUX=enforcing” to “SELINUX=disabled”. 

# This file controls the state of SELinux on the system.

# SELINUX= can take one of these three values:

# enforcing - SELinux security policy is enforced.

# permissive - SELinux prints warnings instead of enforcing.

# disabled - No SELinux policy is loaded.

SELINUX=enforcing

# SELINUXTYPE= can take one of these two values:

# targeted - Targeted processes are protected,

# mls - Multi Level Security protection. SELINUXTYPE=targeted

 Change to the following :

# This file controls the state of SELinux on the system.

# SELINUX= can take one of these three values:

# enforcing - SELinux security policy is enforced.

# permissive - SELinux prints warnings instead of enforcing.

# disabled - No SELinux policy is loaded.

SELINUX=enforcing

# SELINUXTYPE= can take one of these two values:

# targeted - Targeted processes are protected,

# mls - Multi Level Security protection. SELINUXTYPE=targeted