• linux TCP数据包重传过程----小结


     于TCP/IP协议栈的TCP协议的重传功能是由在linux内核源码(net/ipv4/tcp_output.c)中的函数tcp_retransmit_skb()实现的

    代码如下:

    /* This retransmits one SKB.  Policy decisions and retransmit queue
     * state updates are done by the caller.  Returns non-zero if an
     * error occurred which prevented the send.
     */
    int tcp_retransmit_skb(struct sock *sk, struct sk_buff *skb)
    {
    	struct tcp_sock *tp = tcp_sk(sk);
    	struct inet_connection_sock *icsk = inet_csk(sk);
    	unsigned int cur_mss;
    	int err;
    
    	/* Inconslusive MTU probe */
    	if (icsk->icsk_mtup.probe_size) {
    		icsk->icsk_mtup.probe_size = 0;
    	}
    
    	/* Do not sent more than we queued. 1/4 is reserved for possible
    	 * copying overhead: fragmentation, tunneling, mangling etc.
    	 */
    	 	//说明在发送缓存区中消耗了许多内存去做其他的工作(比如分片等,只有1/4的缓存才是保留给这些工作的),暂时不能重传
    	if (atomic_read(&sk->sk_wmem_alloc) >
    	    min(sk->sk_wmem_queued + (sk->sk_wmem_queued >> 2), sk->sk_sndbuf))
    		return -EAGAIN;
    	//检测重传的段,接收方是否已经收到其部分或者全部,如果收到则说明有bug ,否者就调整TCP段的负荷,即删除SKB缓存区
    	//前面部分已经接收到的数据
    	if (before(TCP_SKB_CB(skb)->seq, tp->snd_una)) {
    		if (before(TCP_SKB_CB(skb)->end_seq, tp->snd_una))
    			BUG();
    		if (tcp_trim_head(sk, skb, tp->snd_una - TCP_SKB_CB(skb)->seq))
    			return -ENOMEM;
    	}
    	//根据目的地址等条件获取路由,如果获取路由失败就不能发送
    	if (inet_csk(sk)->icsk_af_ops->rebuild_header(sk))
    		return -EHOSTUNREACH; /* Routing failure or similar. */
    
    	cur_mss = tcp_current_mss(sk);
    
    	/* If receiver has shrunk his window, and skb is out of
    	 * new window, do not retransmit it. The exception is the
    	 * case, when window is shrunk to zero. In this case
    	 * our retransmit serves as a zero window probe.
    	 */
    	 //如果接收方已经减小了窗口,并且带重传的SKB已经不在新的窗口内,则不能重传该SKB,
    	 //有一种情况例外,就是接收方的接受窗口减少为0,在这种情况下会发送0窗口探测段
    	if (!before(TCP_SKB_CB(skb)->seq, tcp_wnd_end(tp)) &&
    	    TCP_SKB_CB(skb)->seq != tp->snd_una)
    		return -EAGAIN;
    
    	if (skb->len > cur_mss) {//如果当前的SKB长度大于MSS,则要进行分段处理
    		if (tcp_fragment(sk, skb, cur_mss, cur_mss))
    			return -ENOMEM; /* We'll try again later. */
    	} else {
    		int oldpcount = tcp_skb_pcount(skb);
    
    		if (unlikely(oldpcount > 1)) {
    			tcp_init_tso_segs(sk, skb, cur_mss);
    			tcp_adjust_pcount(sk, skb, oldpcount - tcp_skb_pcount(skb));
    		}
    	}
    
    	tcp_retrans_try_collapse(sk, skb, cur_mss);
    
    	/* Some Solaris stacks overoptimize and ignore the FIN on a
    	 * retransmit when old data is attached.  So strip it off
    	 * since it is cheap to do so and saves bytes on the network.
    	 */
    	 //有以下Solaris系统的协议栈有时候会忽略重传SKB上带有的FIN标志的payload,将payload全部剥离掉,节省网络流量
    	if (skb->len > 0 &&
    	    (TCP_SKB_CB(skb)->flags & TCPHDR_FIN) &&
    	    tp->snd_una == (TCP_SKB_CB(skb)->end_seq - 1)) {
    		if (!pskb_trim(skb, 0)) {
    			/* Reuse, even though it does some unnecessary work */
    			tcp_init_nondata_skb(skb, TCP_SKB_CB(skb)->end_seq - 1,
    					     TCP_SKB_CB(skb)->flags);
    			skb->ip_summed = CHECKSUM_NONE;
    		}
    	}
    
    	/* Make a copy, if the first transmission SKB clone we made
    	 * is still in somebody's hands, else make a clone.
    	 */
    	TCP_SKB_CB(skb)->when = tcp_time_stamp;
    
    	err = tcp_transmit_skb(sk, skb, 1, GFP_ATOMIC);//发送SKB
    
    	if (err == 0) {
    		/* Update global TCP statistics. */
    		TCP_INC_STATS(sock_net(sk), TCP_MIB_RETRANSSEGS);
    
    		tp->total_retrans++;
    
    #if FASTRETRANS_DEBUG > 0
    		if (TCP_SKB_CB(skb)->sacked & TCPCB_SACKED_RETRANS) {
    			if (net_ratelimit())
    				printk(KERN_DEBUG "retrans_out leaked.
    ");
    		}
    #endif
    		if (!tp->retrans_out)
    			tp->lost_retrans_low = tp->snd_nxt;
    		TCP_SKB_CB(skb)->sacked |= TCPCB_RETRANS;
    		tp->retrans_out += tcp_skb_pcount(skb);
    
    		/* Save stamp of the first retransmit. */
    		if (!tp->retrans_stamp)
    			tp->retrans_stamp = TCP_SKB_CB(skb)->when;
    
    		tp->undo_retrans += tcp_skb_pcount(skb);
    
    		/* snd_nxt is stored to detect loss of retransmitted segment,
    		 * see tcp_input.c tcp_sacktag_write_queue().
    		 */
    		TCP_SKB_CB(skb)->ack_seq = tp->snd_nxt;
    	}
    	return err;
    }
    

    这里注意的到函数tcp_retransmit_skb()最终的是调用函数tcp_transmit_skb(sk, skb, 1, GFP_ATOMIC);将SKB发送出去,而构造TCP的头部信息在函数tcp_transmit_skb()中,下面是函数tcp_transmit_skb()构造TCP头部的片段 所以也就是说在发送队列中的SKB是没有头部的,这也是方便了选择重传等功能

    	/* Build TCP header and checksum it. */
    	th = tcp_hdr(skb);
    	th->source		= inet->inet_sport;
    	th->dest		= inet->inet_dport;
    	th->seq			= htonl(tcb->seq);
    	th->ack_seq		= htonl(tp->rcv_nxt);
    	*(((__be16 *)th) + 6)	= htons(((tcp_header_size >> 2) << 12) |
    					tcb->flags);

                            


    from:http://blog.csdn.net/scdxmoe/article/details/17764109

  • 相关阅读:
    Total Video Converter v3.71 注册码
    Web下载文件
    语音朗读
    SQLSERVER 删除重复记录
    Windows8[启用IIS8 asp.net功能]
    黑链代码
    在ASP.NET中防止注入攻击[翻译]
    Oracle 正确删除archivelog文件
    浅谈网站黑链检测和清除的方法
    解密SQLServer2000加密存储过程,函数,触发器,视图
  • 原文地址:https://www.cnblogs.com/hehehaha/p/6332314.html
Copyright © 2020-2023  润新知