https://kenrockwell.com/audio/bass-management.htm
https://www.axiomaudio.com/blog/bassmanagement
https://en.wikipedia.org/wiki/Bass_management
https://docs.microsoft.com/zh-cn/windows-hardware/drivers/audio/bass-management
https://www.soundandvision.com/content/bass-management-and-lfe-channel
Introduction
Bass management in 5.1 and other multichannel audio playback systems is a well thought-out process by which low-frequency information in the numerous playback channels is distributed to the loudspeakers best able, and most appropriate, to reproduce it.
Bass management is part of a playback system; it is not part of the mixing process.
Bass management is much more than simply sending all the bass to a single subwoofer.
Motion picture sound is completely different from music reproduction. This article addresses the reproduction of motion picture soundtracks at home.
The 5.1 System
Some time around 1990, Tom Holman, inventor of 5.1 and THX sound, was in a SMPTE subgroup meeting where various proposals for multi-channel motion picture sound were being discussed. Everyone was proposing various discrete channel counts and speaker positions, when Tom stood up and proposed a totally ridiculous "5.1 channels." Everyone stopped and stared. "What's a 'point one' channel?"
Tom explained a proposed Low-Frequency Effects, or LFE channel, the "0.1," as part of the movie sound systems we all take for granted today.
The LFE channel is a special low-frequency channel with extra headroom (+10 dB) used most often for reproducing loud booms. In fact, it's actually called the "boom" channel in Hollywood. (Only if you're curious, we get 10 dB more headroom by reducing the audio levels in the LFE channel by 10 dB and increasing the playback level of the LFE channel by 10 dB. Since these are digital as brought home, what's going on is that -20 dBFS in LFE should play at 95 dBC, while the other channels are set to 85 dBC at -20 dBFS if you're following THX reference levels. Yes, a lot of $30 Radio Shack sound level meters are all over big Hollywood studios for setting this!)
Most consumers improperly call the LFE (0.1) channel the "subwoofer channel," but that's not strictly correct outside of the home.
The five other channels are full-bandwidth. They all contain low bass. The 5.1 system (and other "x.1" or "x.2" systems) is at least five full-bandwdth channels, as well as one or two extra LFE (0.1 or 0.2) channel(s). 5.1 is not five little speakers and one subwoofer as are most home systems; that would only be (5x0.9) .1.
Movies are mixed with low bass running all over. There is a lot of very low bass happening in movies, with all the crazy effects which go far deeper than most music. If a helicopter pans over your head from left front to right rear, the bass pans along with it. It's obvious even listening to a movie on your iPad through headphones that the bass is in stereo, although with only one subwoofer, you can't hear the bass move.
In a pro system with five fullrange channels the bass will follow the helicopter, while in most home systems the bass doesn't move and only the higher-frequency information associated with the helicopter does. This is fine for watching a movie; unless you're a mixer you're probably not closing your eyes and only listening to the sound; your brain knows what's going on and the story is told, so all is well.
Professionally however, to get everything that's in a 5.1 soundtrack, if you don't have five big full-range speakers, you need at least six subwoofers: at least five for each of the main channels, and the last for the LFE (0.1) channel.
Bass Management
If you don't have at least five huge full-range speakers (or extra subwoofers) at home, the "bass management" function of your receiver, preamp or player reroutes the bass from the five or more fullrange and LFE (0.1) channels to wherever it can be reproduced best. You may have seen these settings labeled as something else, like "speaker size," in your equipment setup menus.
In most home systems with little speakers and only one subwoofer, this means the bass management system reroutes all the bass from the five fullrange channels into one mono subwoofer, along with the LFE information that was there in the first place.
If some of your speakers are big full-range speakers, the bass management system should be able to be programmed to send bass for those channels to those speakers instead of being hijacked into the mono LFE ("subwoofer") channel.
For instance, if you've got one big pair of left and right speakers, but the usual puny center and surround speakers, setting the bass management properly will route the bass to your front speakers and your subwoofer. Music will now be reproduced properly with stereo bass going to your main speakers, while the boom (LFE) track still comes through the mono subwoofer.
If you have no subwoofer, setting your bass management correctly will route the LFE information to your other speakers.
And so it goes. All you should have to do is set your bass management (or speaker size) menus to tell your processor what you've got, and it should do the rest for you — but you do have to find and program it if you have anything other than 5 small speakers and one subwoofer.
Small and Large
In the bass management setup menu, "Small" and "Large" don't refer to the physical size of your speaker enclosures so much as to whether or not each speaker in the system is capable of reproducing powerful deep bass below 80 Hz (note the emphasis on "powerful"). Nevertheless, the basic rules of physics that dictate small boxes cannot reproduce powerful deep bass can be used as a rough guide to manually adjusting your home theater's bass management.
For example, typical center-channel and surround speakers (and in lots of systems, the main speakers as well) are relatively small so as not to be obtrusive. Most well-designed ones of ample size (not the mini-cubes) will reproduce upper bass — from around 100 Hz and above-smoothly and consistently.
But when deeper bass frequencies below 100 Hz reach those speakers, the satellites do not have the power and air-moving properties (i.e., large-diameter cones) to adequately handle the bass, so the speaker's bass output begins to "roll off" or diminish. That's why you should set your center channel and surround speakers (and the mains if they are bookshelf size) to "Small" in your AV receiver's bass-management menu. The receiver's circuitry then inserts electronic high- and low-pass filters at a preset frequency (or one you manually select) at, typically, 80 Hz or 100 Hz.
80 Hz
Why 80 Hz? Because deep bass below that frequency (the aforementioned energy of the bass drum) is not directional; it's just low-frequency energy that needs the big woofer of a subwoofer (plus its powerful self-contained amplifier) to generate. So that's the process you trigger when you set your center and surround speakers to "Small". The receiver's bass management circuit routes the deepest bass to the subwoofer and all the upper bass and highs to the center and surround speakers (and to the main speakers if they are bookshelf models).
Note too that the digital filters inside your AV receiver don't just suddenly cut off all frequencies at 80 or 100 Hz. They have "slopes," so the process of extracting deep bass is a gradual one - as the bass gets deeper, the crossover filters remove more and more of it for the subwoofer and gradually send less of it to the smaller satellite speakers. The bass frequency ranges of sub and satellites overlap, so a seamless and inaudible transition occurs between the subwoofer and your center and surround speakers' upper bass and midrange. That's why you shouldn't notice or "hear" deep bass from the subwoofer in a conventional sense. Properly set up, the deepest bass should seem to come from the main front speakers in your system, because the sub is only supplying the lowest energy component of low-frequency sounds. (Depending on where the subwoofer is located you may hear knick-knacks vibrating or resonanating — even picture frames — which are set into motion by the bass energy from the sub.)
Audio and home theater enthusiasts often worry about "losing bass from the QS8s or the rears" as one Axiom customer recently put it. That would only occur if he were to set his surround speakers to "Large." Deep bass would then be sent to the surrounds, which aren't able to produce deep bass.
If you use floorstanding front left and right speakers, most receivers enable several options that let you set the mains to "Large" and choose whether or not to have the AV receiver also direct bass to the subwoofer. That may work well in lots of rooms, but be certain that your AV receiver's bass management filters also direct bass from the center and surrounds to the subwoofer and/or to the Large mains. Most do.